Goed antwoord! heb ik over het hoofd gezien in de spec. nb nog wel gebruikt voor de mastberekening.
Die 3bmox zit op 0.58 m2. zal eens zien wat dat doet op 5cm boven de rotor... (lineair terugrekenen zou 5/60 * 0.58=0.048 m2 belasting opleveren. maar dit lijkt mij te snel door de bocht....)[/quote]
Toch kan dat zo wel.
In de doc van de Yaesu rotor staat:
Mounting of the rotator on a pole or mast results in a significant de-rating of the size of the antenna which can be
mounted, due to the tremendous bending forces applied to the rotator’s clamps. For pole mounting, the product of
multiplying the [Antenna Wind Load Area (in m2)] by the [Height of the Antenna Mast (in m)] must be less than 0.45
(G-1000DXC) or 0.8 (G-2800DXC). See below Table and Figure
"
Dus je mag inderdaad lineair terugrekenen. Dus nogal wat op de rotor zetten zolang de arm maar kort is.
