--- OM2500---
Und Output wird wie immer mittels chinesischer PL-Stecker ausgeführt...
Auch Parallelspeisung, die gleichen Schalter wie im ACOM und sieht insgesamt von den Innereien her exact gleich aus.
Und jetzt überleg mal einer, was passiert wenn ich bei diesem "Device" im laufenden Betrieb die Antenne kurzschließe.
http://www.difona.de/pdf_de/omom2500hf_manual.pdf
ACOM 1000
- on4ma
- Berichten: 549
- Lid geworden op: 01 nov 2008, 11:52
- Roepletters: ON4MA
- Locatie: Belgie
- Contacteer:
Re: ACOM 1000
Je hebt het bij het rechte eind. Inderdaad geen QSkSteef schreef:Van de site onder FAQ bij de om2500:
Q: Is it easy to use this amplifiers and how to get new tubes ?
A: YES - IT´s EASY ! Download the .pdf description and you will see it. You don´t need SWR-meter and with the build-in tuning-indicator you can see the best tuning position. New tube you can get here : http://www.dl3jj.de
Q: Amplifier is suitable for QSK ? There is a vacuum-relay used ?
A: Amplifier is not suitable for QSK. Therefore no vacuum relay is needed.
Q: I have only one phase. How much output is possible ?
A: You will not have the full output. But I (DL3JJ) have tested at dummy-load on one phase 55W input for 2200W output. It´s bether to use 2 phases, of sure !
http://www.rrdxa.eu/rrdxa/stories/test- ... m2500.html