Tecsun PL-365 met BNC i.p.v. telescoopantenne

Alles over ontvangers en toebehoren.
Bericht
Auteur
Gebruikersavatar
Thijzer
Berichten: 1392
Lid geworden op: 25 feb 2011, 10:25

Tecsun PL-365 met BNC i.p.v. telescoopantenne

#1 Bericht door Thijzer »

De Tecsun PL-365 (te koop via Ebay of http://www.elektrodump.nl/nl/ontvanger/ ... anger.html) is een mooie wereldontvanger mét HF amateurbanden! Je kunt in USB of LSB luisteren en er zit een BFO op voor nauwkeurig intunen. Ik gebruik 'm regelmatig als FM radio maar heb ook al een aantal keren de ronde op 80m beluisterd.

Jammer genoeg beschikt de radio alleen over een telescoopantenne en die is niet helemaal geschikt. Niet alleen is hij te kort, hij rammelt ook een beetje waardoor de ontvangst net zo hard rammelt. En een externe antenne moet je met een krokodillenklemmetje of zo eraan maken, verre van ideaal. Met de schuifmaat ontdekte ik dat het gat waar de antenne doorheen komt precies even groot is als de schacht van een BNC connector. Tijd voor een modificatie!
(tekst is in het Engels i.v.m. plaatsing op mods.dk)
Voor de knutselaars: er is zelfs ruimte voor een pre-amp of om een voeding via de coax te maken voor een pre-amp een stuk verderop... Ideeën zijn welkom!

Step 1 – opening the case
Unscrew 2 long screws on the back, 1 short on the back holding the original antenna and 4 short screws underneath the batteries. Pull the antenna through the hole on top of the radio.
Gently lift the front half of the case, careful with the wires running to the speaker and place it right next to the rest of the radio. You will see the PCB with the display on top.
20180707_205004a.jpg
Step 2 – removing the display
The PCB with the display is connected to the back PCB by a plug-in connector and it is secured by 3 short screws. Unscrew them and gently lift the PCB, disconnecting it from the back PCB. This will reveal the back PCB.
20180707_204231b.jpg

Step 3 – solder and glue the BNC connector
The BNC connector fits exactly in the hole of the original antenna, however a nut can not be placed so the connector has to be glued in place.
Solder two wires to the BNC connector: the center goes to the original antennaterminal (left – red wire) and the GND goes to a ground connection on the PCB. There are several options, the best may be the GND connection on the back of the PCB.
After soldering, glue the connector in place with epoxy or hot glue. Put a little piece of insulation over the connector to prevent shorting in the back of the display PCB.

Step 4 – assembly
After applying glue and insulation, immediately assemble the radio by putting the display PCB back in place and screwing the 3 little screws. Place the top half of the case back on and screw in the 4 small screws and 2 large screws in the back.
Now check if the connector is straight in place and correct if needed (that’s why you shouldn’t wait too long before assembly).
You’re finished! Your radio now has a BNC connector that can hold a telescopic whip or longwire, loop or whatever you want to use to receive SW.
It’s a fun radio and the reception will improve with a reasonable antenna!

Plaats reactie